Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Inconsistent results via setting different start and end time with the same time step
Posted 2022年2月24日 GMT-5 05:55 Structural & Acoustics, Heat Transfer & Phase Change, Studies & Solvers Version 5.6 2 Replies
Please login with a confirmed email address before reporting spam
I am solving a time-dependent problem, where I meet an issue related to the convergence. I set six different start and end time with the same time step 0.02ns, for instance, 0 - 10ns, 0 - 20ns, 0 - 30ns, 0 - 40 ns, 0 - 50ns, and 0 - 60ns. However, they give me inconsist results at 10ns, see the figure below. Both Fully coupled and Segregated solvers show the same behaivour. Could anyone give me some tips about this behaviour in COMSOL?
Attachments:
Please login with a confirmed email address before reporting spam
I'll take a wild guess that perhaps you may be allowing Comsol to automatically adjust the size of your time steps? Try setting your time stepping to "Manual". I've attached a piece of a screenshot to show you an example. But consider posting your .mph file to the forum for more detailed advice.
-------------------Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
Attachments:
Please login with a confirmed email address before reporting spam
Dear Robert,
It helped. Thank you very much!
Best regards, Jian