Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
looking for a way to save the modeling time
Posted 2012年8月4日 GMT-4 04:55 Low-Frequency Electromagnetics, Studies & Solvers Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am using the time-dependent physics and my 3D model is applied by a sinusoidal voltage.
the modeling is running in one period T with 100 steps and it may done in 30 mins if I was lucky.
but most of time it will waiting at 0% for solving the linear system even over one night.
so is there any way to speed up the modeling cause i really need to run a lot of frequencies.
thanks.
Sam
I am using the time-dependent physics and my 3D model is applied by a sinusoidal voltage.
the modeling is running in one period T with 100 steps and it may done in 30 mins if I was lucky.
but most of time it will waiting at 0% for solving the linear system even over one night.
so is there any way to speed up the modeling cause i really need to run a lot of frequencies.
thanks.
Sam
1 Reply Last Post 2012年8月4日 GMT-4 05:21
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
It depends: time series solvers are for transient cases, if you have a continuous periodic condition, use a harmonic development that you get with a frequency sweep solver, check the physics equation, you will notice the harmonic development of the equations
--
Good luck
Ivar
It depends: time series solvers are for transient cases, if you have a continuous periodic condition, use a harmonic development that you get with a frequency sweep solver, check the physics equation, you will notice the harmonic development of the equations
--
Good luck
Ivar