Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Coupling 2D and 1D elements for diffusion simulation
Posted 2023年3月15日 GMT-4 13:50 Chemical Reaction Engineering, Geometry Version 5.6 0 Replies
Please login with a confirmed email address before reporting spam
Hello,
I am trying to simulate the diffusion of water into a 2D element. I am using the transport of diluted species to model this process. However, in one part of the model the gradient in one of the directions disappears. In theory this means that this section of the model can be treated as 1D diffusion. I was wondering if it is possible to treat this part of the model as a 1D diffusion problem and couple it with the 2D component of the model. I have limited experience with COMSOL so any help would be appreciated!
I have seen online that you should use General extrusion or General projection, I have not used these elements yet and would appreciate help on how to apply them to my model
Hello D JP
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.