Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing errors

Please login with a confirmed email address before reporting spam

I just stated using COMSOL and I'm trying to build two helical coils stacked on top of each other with a ~5cm gap. Whenever I attempt to build the mesh I get the error tree,

failed to generate mesh for face>> failed to insert point >> empty cavity created.

I also receive several geometric boundary sections.

I've read about creating a sweep mesh but I keep receiving an "inverted element `" error.

I've attached the .mph file to illustrate the issue


0 Replies Last Post 2012年10月26日 GMT-4 13:48
COMSOL Moderator

Hello Eric Herrera

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.