Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Adsorption model of diluted species

Please login with a confirmed email address before reporting spam

I am simulating an adsorption process in a channel. The channel geometry is hollow in the center and has a thin porous layer on the four walls into which the gas is adsorbed. The gas is in a very dilute form which is given at inlet through the central hollow region of the channel with a certain uniform velocity. I am trying to obtain breakthrough curves at the outlet. My simulation runs perfectly fine till the gas reaches almost half the channel. However mass balance is lost once the gas reaches near the exit. The breakthrough curves show higher concentration of the gas than given at the inlet which shouldn't be. I tworks well for cetain values of inlet velocity, concentrationa nd other input parameters for not for others. Can anyone please guide me in this. I tried to resolve the mesh but it didn't work.


0 Replies Last Post 2023年8月31日 GMT-4 07:49
COMSOL Moderator

Hello Hina ..

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.