Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

initial/boundary conditions set as step dependent

Posted 2024年3月26日 GMT-4 01:36 4 Replies

Carl Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

In a study with multiple steps, I hope to use different initial/boundary conditions. If initial/boundary conditions can be set as step dependent, all steps can be run in one go during the same study. Can initial/boundary conditions be set as step dependent?

4 Replies Last Post 2024年4月2日 GMT-4 22:41
Magnus Ringh COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 months ago 2024年3月27日 GMT-4 08:20

Hi Carl,

The reply here is the same as the one Henrik gave you to another question:

You can use Modify model configuration for study step in the settings for the study step.

If, however, it is only about having different sets of loads (or constraints), you may find the load case handling functionality more natural.

Best regards,

Magnus

Hi Carl, The reply here is the same as the one Henrik gave you to another question: You can use *Modify model configuration for study step* in the settings for the study step. If, however, it is only about having different sets of loads (or constraints), you may find the load case handling functionality more natural. Best regards, Magnus
Carl Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 months ago 2024年3月31日 GMT-4 01:29

Thank you Dr Magnus, where can we find the 'load case handling functionality'?

Thank you Dr Magnus, where can we find the 'load case handling functionality'?
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 months ago 2024年4月2日 GMT-4 02:50

Take a look at, for example, this model:

https://www.comsol.com/model/tapered-cantilever-with-two-load-cases-12681

-------------------
Henrik Sönnerlind
COMSOL
Take a look at, for example, this model:
Carl Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 months ago 2024年4月2日 GMT-4 22:41

that's very helpful thank you Drs Sönnerlind and Ringh.

that's very helpful thank you Drs Sönnerlind and Ringh.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content