Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Identity and contact pair
Posted 2013年3月26日 GMT-4 10:24 Low-Frequency Electromagnetics Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am trying to build a model in which it is not contacting in geometry but continuous in physical quantity between two surfaces in 3D model. So I use the "form an assembly" to build the model and define a identity pair between the two surfaces mentioned before. At the same time, I define a continuity boundary condition under the physics node and use the 'copy face' to establish the mesh for this identity pair.
However, I don't get the right result, for the voltage in the object is not gradiently distributes, which means that this identity condition setting is not correct.
But when I use the contact pair instead, I get the result which I need.
Thank you!
I am trying to build a model in which it is not contacting in geometry but continuous in physical quantity between two surfaces in 3D model. So I use the "form an assembly" to build the model and define a identity pair between the two surfaces mentioned before. At the same time, I define a continuity boundary condition under the physics node and use the 'copy face' to establish the mesh for this identity pair.
However, I don't get the right result, for the voltage in the object is not gradiently distributes, which means that this identity condition setting is not correct.
But when I use the contact pair instead, I get the result which I need.
Thank you!
1 Reply Last Post 2013年3月26日 GMT-4 13:02
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
strange, as "contact pairs are for setting up contact physics for "solid" in caontact, identity pairs with continuity is the "natural default"
--
Good luck
Ivar
strange, as "contact pairs are for setting up contact physics for "solid" in caontact, identity pairs with continuity is the "natural default"
--
Good luck
Ivar