Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

error test failures

Posted 2014年1月2日 GMT-5 06:22 Plasma Physics, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers Version 4.2a, Version 4.3, Version 4.3b 2 Replies

Amir Zamani
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi
i use ccp module for simulation,my time range is range(0,5e-5,0.001) but when i compute model times go 7.579247e-019 to this and report this error
Repeated error test failures. May have reached a singularity.
Time : 7.579247088737066e-019
Last time step is not converged.

how can i solve it?
thanks
2 Replies Last Post 2014年9月3日 GMT-4 08:03
Luke Gritter Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年1月6日 GMT-5 11:25
Amir,

Capacitively coupled plasma models often have convergence problems due to the sheath dynamics and the large number of cycles required to reach periodic steady state. Here are a few items that can help facilitate convergence:

1) Avoid sharp corners (especially on the electrodes)
2) Use a very fine mesh everywhere the gradients associated with the sheath will appear during the solution process
3) Make sure you are using realistic electron transport coefficients and ion mobilities

Good luck!
--
Luke Gritter
AltaSim Technologies
Amir, Capacitively coupled plasma models often have convergence problems due to the sheath dynamics and the large number of cycles required to reach periodic steady state. Here are a few items that can help facilitate convergence: 1) Avoid sharp corners (especially on the electrodes) 2) Use a very fine mesh everywhere the gradients associated with the sheath will appear during the solution process 3) Make sure you are using realistic electron transport coefficients and ion mobilities Good luck! -- Luke Gritter AltaSim Technologies
Zhiming Huang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年9月3日 GMT-4 08:03
See you again Mr. Gritter！
And I meet the same problem——
"Repeated error test failures. May have reached a singularity.
Time : 1.000005239532391e-007
Last time step is not converged."

The model is a dielectric barrier discharge , and the domain is a rectangle, I add the Electic Potential to the upper edge, --- will it be the sharp corners that results in the erro?
See you again Mr. Gritter！ And I meet the same problem—— "Repeated error test failures. May have reached a singularity. Time : 1.000005239532391e-007 Last time step is not converged." The model is a dielectric barrier discharge , and the domain is a rectangle, I add the Electic Potential to the upper edge, --- will it be the sharp corners that results in the erro?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content