Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Contact Modelling; Force application

Posted 2010年4月6日 GMT-4 12:54 0 Replies

Nikhil Alexander
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone,

I'm a relative novice at COMSOL, so I might have made quite silly mistakes. For the attached model, there seems to be no interaction between the upper and lower sections. The upper section seems to penetrate the lower even though contact pairs have been defined.

Also, how is it possible to apply a force/displacement at a specific region on a boundary? In this case the displacement is applied on boundary 40. How will it be possible to apply a load on a part of this boundary?

Many thanks,
Nick

Attachments:

0 Replies Last Post 2010年4月6日 GMT-4 12:54
COMSOL Moderator

Hello Nikhil Alexander

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content