Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Guidance to solve Heat transfer analysis problem (comsol 4.0)
Posted 2010年6月8日 GMT-4 20:43 Heat Transfer & Phase Change, Battery Design, Modeling Tools & Definitions Version 4.0 2 Replies
Please login with a confirmed email address before reporting spam
My name is Fahid Amin and I have a heat transfer problem to solve. I have a box enclosing a fuel cell system and in which there are sources of heat generation like stack, circuit board along with dissipator, a pump which adds heat in the box when it is running. the box which contain fuel cell system is internally cold using forced convection. the exit flow rate of air is 0.052 m3/sec. But when I try to compute the solution I get an error of maximum number of newton iterations has reached.
I have tried to solve this problem using laminar flow . Please guide me how can i solve it for flow rate of 0.052m3/sec.
Thanking you in advance.
Yours truly,
Fahid Amin
Attachments:
Please login with a confirmed email address before reporting spam
I only started using COMSOL a few weeks ago, but I've had the same problem in the past and my solution is to increase the number of allowable iterations. You should spend some time looking through the generated study to learn a little more about the different options you can change. If you do, you'll find the number of allowable iterations as well.
Thanks,
Joe
Please login with a confirmed email address before reporting spam