Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Electrical Circuits Interface to Physical Model in Comsol Multiphysic v4.4
Posted 2015年3月8日 GMT-4 05:45 1 Reply
Please login with a confirmed email address before reporting spam
I am a student of MS ElectricaL Engineering and am simulating 3 Phase Power transformer in COMSOL Multiphysics v4.4. I have build a model but i am facing problem to interface it to electrical circuit e.g Connecting Input source (Primary Side) and a resistor to the input sides of three phase Power Transformer. also I am having problems in Naming the nodes , how to add resistors node name. Kindly any help will be appreciated.
Regards:
Regards:
Attachments:
1 Reply Last Post 2015年3月8日 GMT-4 07:49
Please login with a confirmed email address before reporting spam
Posted:
10 years ago
Hi
About your model,You can refer to the case model of the transformer.Maybe helpful to you.
good luck.
About your model,You can refer to the case model of the transformer.Maybe helpful to you.
good luck.