Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Time Dependent Study of a Cantilever Beam with Step Input

Please login with a confirmed email address before reporting spam

Hello,

I am trying to simulate a cantilever beam, fixed-free, undergoing an applied point force at the free end of the beam, simulated as a step input. My goal is to obtain the beam total displacement.

I created a model of the beam in Matlab for the unit step response of a system and have plotted the response with respect to time. I have attached the Matlab file.

How do I set up the step input properly in COMSOL as a specified force?

Within my model of the cantilever beam I have assigned values for damping. Where do I assign damping in COMSOL? How do I change these values? I have looked into the Time Dependent>Solver Configurations>Solver2>Time Dependent Solver 1>Fully Coupled> Newton Method and found a damping value here and my understanding is that it helps to converge the solution. Does this values also affect the decrement of the oscillations?

Thank you for your help!


0 Replies Last Post 2015年3月11日 GMT-4 13:33
COMSOL Moderator

Hello Michael Simpson

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.