Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Select boundaries inside a cube

Posted 2015年6月13日 GMT-4 16:25 Geometry Version 5.0 3 Replies

Kevin Bartoloni
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I use COMSOL 5. My geometry is a cube and inside of the cube there is a small sphere. To perform my model, I need to select the boundaries of the sphere. The problem is that I cannot select the boundaries crossing the cube...I can select only the boundaries of the cube...

Have you a method to select the boundaries of the sphere crossing the cube ?

Thank you for your help.

Kevin Bartoloni (PhD)
3 Replies Last Post 2015年6月16日 GMT-4 05:44
Lasse Murtomäki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年6月15日 GMT-4 16:29
You must use selection list. Activate it from the main ribbon, more windows.

Lasse
You must use selection list. Activate it from the main ribbon, more windows. Lasse
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年6月15日 GMT-4 16:32
See www.comsol.com/community/forums/general/thread/82321/
See http://www.comsol.com/community/forums/general/thread/82321/
Kevin Bartoloni
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年6月16日 GMT-4 05:44
Thank you !
Thank you !

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content