Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Issue with friction force appliance

Posted 2015年9月29日 GMT+8 17:55 Structural Mechanics Version 4.4 3 Replies

Anastasiia Tukmakova
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, have a problem with friction force adding. Have gone to "Solid mechanics">"contact">"friction force". Have added this section, but can't choose the boundaries, they are not available for this physics appliance and every boundary has a status "not applicable". The same status has every "free" boundary. What can be the reason of such behavior?
3 Replies Last Post 2015年10月15日 GMT+8 22:18
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2015年9月29日 GMT+8 20:14
Anastasiia,

Be default, Comsol selects all boundaries when you add “Friction” sub-node to the “Contact” node. Most boundaries are not participating in the contact and have status “not applicable”. However, those boundaries that are participating in the contact do not have this status and should be available for friction condition. May be, you just don’t see these boundaries – try to scroll down through all boundaries in the “Boundary Selection” section, , as shown in the attached image.

Regards,
Sergei
Anastasiia, Be default, Comsol selects all boundaries when you add “Friction” sub-node to the “Contact” node. Most boundaries are not participating in the contact and have status “not applicable”. However, those boundaries that are participating in the contact do not have this status and should be available for friction condition. May be, you just don’t see these boundaries – try to scroll down through all boundaries in the “Boundary Selection” section, , as shown in the attached image. Regards, Sergei

Attachments:

Anastasiia Tukmakova
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2015年10月15日 GMT+8 17:07
Thank you, Sergei
all the boundares have "not applicable" status. Is there any conditions when friction (or any other force) can be not applicable at all? Maybe when some other forceshave been already applied to all the boundaries/domains?
Thank you, Sergei all the boundares have "not applicable" status. Is there any conditions when friction (or any other force) can be not applicable at all? Maybe when some other forceshave been already applied to all the boundaries/domains?
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2015年10月15日 GMT+8 22:18
Anastasiia,

I never had such issue with friction at contact surfaces. It would be helpful to see what the problem is if you can upload your model.

Regards,
Sergei
Anastasiia, I never had such issue with friction at contact surfaces. It would be helpful to see what the problem is if you can upload your model. Regards, Sergei

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content