Load Cell Design Using COMSOL Multiphysics
COMSOL Multiphysics was used to design a binocular load cell. A three-dimensional linear solid model of the load cell spring element was studied to quantify the high-strain regions under loading conditions. The load cell was fabricated from 6061 aluminum, and general purpose Constantin alloy strain gages were installed at the four high-strain regions of the spring element. The four gages were wired as a full Wheatstone bridge configuration and total strain was measured for applied loads ranging from 0-2.5 kg in 100 g increments. Model total strain was measured using point probes at each of the four strain locations, and with a load parametric analysis. Absolute mean model-predicted strain was 1.41% of measured strain. The load cell was highly linear.
下载
- palladino_presentation.pdf - 0.82MB
- palladino_poster.pdf - 0.82MB
- palladino_paper.pdf - 1.91MB
- palladino_abstract.pdf - 1.39MB