学习中心

Course:

Performing Optimization in COMSOL Multiphysics

Topology Optimization Applications and Comparing Optimization Techniques


In Part 10, the final part of our course on optimization, we discuss a wide range of topology optimization applications, highlighting tutorials of the following models:

  • Tesla microvalve: The ratio between the hydraulic resistance for the two flow directions is maximized. This example is available in three versions: parameter, shape, and topology optimization. There are two versions of the topology optimization model: one with stationary flow and one with transient flow.
  • Porous catalyst: The reaction rate is maximized.
  • Magnetic circuit: The shape of a nonlinear iron yoke is optimized so that it maximizes its performance while minimizing the weight.
  • Material distribution in a hook: The objective is to maximize stiffness subjected to a mass constraint. This model also demonstrates how to export an STL-file.
  • Material distribution in a bracket: Similar to the hook model, the goal is to maximize stiffness while minimizing mass, but continuation is used to avoid bad local minima.

We also review the different types of optimization discussed throughout this course and compare them, from the differences in the levels of complexity to the kinds of results that can be generated. In addition, we touch upon the phases of the design process that each optimization is typically used in.

The course ends with an overview of some additional optimization tutorial model examples, including:


Further Learning

Along with exploring any of the tutorial models listed here, we recommend reading our "How to Use Topology Optimization Results as Model Geometries" blog post.


请提交与此页面相关的反馈,或点击此处联系技术支持