Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Initial values for Added Geometry in Time Dependent Loop Simulation

Posted 2017年9月12日 GMT-4 04:23 Heat Transfer & Phase Change 0 Replies

Mridul
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

In my time dependent problem my geometry is devided into two parts A1 and A2. The transient solution in carried out in two phase.

Phase 1: Domain A1 is considered and A2 is ignored and results are calculated for time "0" to "t1".
Phase 2: Domain A1 and A2 is considered and Initial values for domain A1 is used from Phase-1 solution.


My query is how can I initialize the initial values for domain A2. By default it is getting "0".
Thanks

Mridul
0 Replies Last Post 2017年9月12日 GMT-4 04:23
COMSOL Moderator

Hello Mridul

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content