Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Isolating eigenfrequency analysis for modes of interest

Posted 2017年10月25日 GMT-4 14:26 MEMS & Nanotechnology 2 Replies

Valerie Scott
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Is there a way to isolate for specific modes of interest in running an eigenfrequency analysis without knowing at what frequency that mode will occur? For example, if I have a resonator structure suspended by clamped arms, when you run an eigenfrequency analysis, you'll get a bunch of modes that involve those arms. Let's say I'm looking for the first bending mode of the larger structure, or a thickness mode, or a shear mode, but I don't care about the modes involving the arms except to factor in damping losses, calculating Q, etc. Is there a way to select for areas of the structure to isolate for the modes of interest?

Thanks,

2 Replies Last Post 2017年10月26日 GMT-4 04:33
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年10月25日 GMT-4 21:40

I have suggested one way to approach this, see

http://dwgreveconsulting.com/gallery/sortingmodes.pdf

What you do is come up with some quantity (that can be calculated as a Derived Value) that is large or small for the particular modes of interest. Then do an eigenfrequency analysis and plot that quantity as a function of eigenfrequency.

For a particular problem I was interested in (surface wave modes) it is easy to look for modes that have minimal energy density in the bulk and large energy density at the surface.

D.W. Greve DWGreve Consulting

I have suggested one way to approach this, see http://dwgreveconsulting.com/gallery/sortingmodes.pdf What you do is come up with some quantity (that can be calculated as a Derived Value) that is large or small for the particular modes of interest. Then do an eigenfrequency analysis and plot that quantity as a function of eigenfrequency. For a particular problem I was interested in (surface wave modes) it is easy to look for modes that have minimal energy density in the bulk and large energy density at the surface. D.W. Greve DWGreve Consulting
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年10月26日 GMT-4 04:33

Hi,

For solid mechanics, the mode participation factors can be used to get some insight into the type of modes.

An example of this can be found in

https://www.comsol.com/model/truss-bridge-designer-30831

where the participation factors are scanned using a method coded in the Application Builder (mDefaultMode). The purpose is to automatically plot the most interesting mode (the first mode of the bridge deck).

Regards,

Henrik

-------------------
Henrik Sönnerlind
COMSOL
Hi, For solid mechanics, the mode participation factors can be used to get some insight into the type of modes. An example of this can be found in https://www.comsol.com/model/truss-bridge-designer-30831 where the participation factors are scanned using a method coded in the Application Builder (mDefaultMode). The purpose is to automatically plot the most interesting mode (the first mode of the bridge deck). Regards, Henrik

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content