Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
meshing 3D coil
Posted 2011年10月3日 GMT-4 16:16 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I am attempting to mesh a complicated 3D coil. At first I thought I would need to mesh the entire object to obtain the fields after applying a current, but I believe it will suffice for my purposes if I just make the volume wires into lines. Is there an easy way to take a 3D coil and turn it into lines (no surface area) so that I can easily put a current through it? My file is too big to attach, so if you would like to take a look at it, email me.
Thanks,
Jason
I am attempting to mesh a complicated 3D coil. At first I thought I would need to mesh the entire object to obtain the fields after applying a current, but I believe it will suffice for my purposes if I just make the volume wires into lines. Is there an easy way to take a 3D coil and turn it into lines (no surface area) so that I can easily put a current through it? My file is too big to attach, so if you would like to take a look at it, email me.
Thanks,
Jason
1 Reply Last Post 2011年10月4日 GMT-4 01:22
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
You need to generate the line in your geometry, in V4 you have the helix generation, but will COMSOL accept a single line/edge inside a 3D geometry, without an attached boundary, not sure (? TBC)
--
Good luck
Ivar
You need to generate the line in your geometry, in V4 you have the helix generation, but will COMSOL accept a single line/edge inside a 3D geometry, without an attached boundary, not sure (? TBC)
--
Good luck
Ivar