Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D topology optimization for natural convection heat sinks

Posted 2024年10月9日 GMT-4 02:08 Fluid & Heat, Optimization Version 5.3a 1 Reply

Alex
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there,

I am trying to replicate the heat sink example shown in this paper "Topology Optimisation for Natural Convection Problems". However, i was not able to achieve a similar result shown in this paper I am not too sure what is the problem with my model.

Looking forward to your advice

1 Reply Last Post 2024年10月9日 GMT-4 03:50
Kristian Ejlebjærg Jensen COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 months ago 2024年10月9日 GMT-4 03:50

Hi Alex

A COMSOL engineer can give feedback on the model, if you upload it to comsol.com/support.

Best regards,

Kristian E. Jensen

Hi Alex A COMSOL engineer can give feedback on the model, if you upload it to comsol.com/support. Best regards, Kristian E. Jensen

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content