Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

restraining normal velocity vector in a curved surface

Posted 2013年4月26日 GMT-4 12:41 Fluid & Heat, Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.3a 0 Replies

Pooyan Tirandazi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I'm trying to emulate a two phase flow with the laminar single phase module, but I could not find a way to restrict the normal velocity from flowing through a curved surface.

It's like a slip wall boundary condition (U dot n) in the module, but instead I wan't to introduce a realistic shear stress.

I tried making 3 pointwise constraints where I used realdot(abs(spf.U),nx), realdot(abs(spf.U,ny), realdot(abs(spf.U,nz) at the interface, but I'm still having flow through the surface.

Is there any suggestions to prevent the flow from flowing through a curved surface, but still retains the tangential velocity?

Thank you!

TJ
0 Replies Last Post 2013年4月26日 GMT-4 12:41
COMSOL Moderator

Hello Pooyan Tirandazi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content