Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Why does my S11 parameter change when adding a 2nd inactive port?

Posted 2014年1月14日 GMT-5 12:08 RF & Microwave Engineering, Results & Visualization Version 4.3b 2 Replies

Bryan Adomanis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

When looking at off-normal reflection from a periodic structure, my S11 results change when I add a second, unexcited periodic port (S2x). My first periodic port is sending a TM mode in Hy, with amplitude H0 = E0/377[1/S], and thus ewfd.S11 represents the reflected TM response. My results look as expected.

I then added a 2nd inactive port to get results of a single field component (E = Ex, with amplitude E0), expecting ewfd.S21 to consist of just the results along Ex. However, this changes the S11 results! Why?

My only guess is if port 2 is absorbing the Ex component, thus port 1 collects only the remainder? (in this case, the remainder would be mostly Ez components, and possibly a small amount of Ey from chirality)

Thanks for your time and consideration on the matter!

-Bryan
2 Replies Last Post 2014年6月27日 GMT-4 07:33
Robert Koslover Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年1月17日 GMT-5 12:11
In most cases, any change to any boundary condition that intercepts any of the wave power from your port#1 could be expected to change S11.
In most cases, any change to any boundary condition that intercepts any of the wave power from your port#1 could be expected to change S11.
Affar Karimullah
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年6月27日 GMT-4 07:33
Hi,
I was curious reading about your problem and how you manage to seperate the Ex and Ey components using definitions in the port. Hence I wanted to ask, does specifying Ex=1 in port 2 tell comsol to measure only the Ex component when the input from port 1 is Ey=1 (turned on) . Secondly can this be used to measure Ex and Ey components from diffraction orders?
Hi, I was curious reading about your problem and how you manage to seperate the Ex and Ey components using definitions in the port. Hence I wanted to ask, does specifying Ex=1 in port 2 tell comsol to measure only the Ex component when the input from port 1 is Ey=1 (turned on) . Secondly can this be used to measure Ex and Ey components from diffraction orders?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content