Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

PML,eigenfrequency analysis

Please login with a confirmed email address before reporting spam

Dear all,
I'm new to Comsol sofware.

Could someone please tell me if I can use PML in eigenfrequency analysis mode in piezoelectric devices interface of structural mechanics Module. I'm using Comsol version 4.3a.

Thanks in advance.

5 Replies Last Post 2016年2月17日 GMT-5 02:17

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年3月20日 GMT-4 08:18
Hi

I have used PML in solid mechanics model for eigen frequency analysis. It did work. I guess it should work for piezoelectric as well.
Hi I have used PML in solid mechanics model for eigen frequency analysis. It did work. I guess it should work for piezoelectric as well.

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年3月23日 GMT-4 22:24
Thank you so much. I tried it and it seemed to be properly work. By the way, could you please share your experience in choosing PML parameters (e.g scale factor,...).

Thanks again.
Thank you so much. I tried it and it seemed to be properly work. By the way, could you please share your experience in choosing PML parameters (e.g scale factor,...). Thanks again.

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2016年2月16日 GMT-5 18:18
Hi Ruzbeh,

How do you apply PML in structural mechanics module? I do not see any option for PML.

Regards,
Gyani
Hi Ruzbeh, How do you apply PML in structural mechanics module? I do not see any option for PML. Regards, Gyani

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2016年2月16日 GMT-5 18:18
Hi Ruzbeh,

How do you apply PML in structural mechanics module? I do not see any option for PML.

Regards,
Gyani
Hi Ruzbeh, How do you apply PML in structural mechanics module? I do not see any option for PML. Regards, Gyani

Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2016年2月17日 GMT-5 02:17
Hi,

You select a domain as PML under Component->Definitions.

Regards.
Henrik
Hi, You select a domain as PML under Component->Definitions. Regards. Henrik

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.