Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

One circle is split into four 1/4 arcs

Posted 2014年6月2日 GMT-4 13:59 Version 5.2 1 Reply

Jiacheng Wu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there,

When I create a circle or cylinder surface in COMSOL, it is always separated into four 1/4 parts. Does anyone know if I can make COMSOL not to split into 4 parts or is there a way I can unite these four 1/4 arcs or surfaces as one arc or one surface?

Thanks a lot.
1 Reply Last Post 2016年8月24日 GMT-4 00:21
COMSOL Moderator

Hello Jiacheng Wu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reed Teyber
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年8月24日 GMT-4 00:21
Hello,

I had the same question, found this post, and solved my problem so I thought I would reply for others who have the same problem.

Simply go to the geometry tab, ->"Virtual Operations", select "Ignore Vertices", you can then select the four vertices of the circle.

At least for me, this solved my meshing problems with overlapping circles. Hope this helps someone,


Reed
Hello, I had the same question, found this post, and solved my problem so I thought I would reply for others who have the same problem. Simply go to the geometry tab, ->"Virtual Operations", select "Ignore Vertices", you can then select the four vertices of the circle. At least for me, this solved my meshing problems with overlapping circles. Hope this helps someone, Reed

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content