Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Swept Mesh

Posted 2010年4月27日 GMT-4 00:37 0 Replies

Omar Canales
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello All

I am trying to do a swept mesh. This is Y-shape microfluidic channel (3-D). It works fine for a velocity profile. However, for a concentration profile (in which I have a diffusion zone where the liquids merge) I don't get a smooth gradient. I can even notice the triangular mesh. What I'm doing is meshing the faces (inlet faces = sources) and sweeping the mesh over the entire length of the device. When I mesh these faces I can not get as many elements as I want. With a normal mesh I get about two elements and with extremely fine mesh I get few more triangles. Is there a ways to refine this "source" faces? Or get a better swept mesh at all? Any help is appreciated.

Thanks,

-Omar
0 Replies Last Post 2010年4月27日 GMT-4 00:37
COMSOL Moderator

Hello Omar Canales

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content