Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
GEOMETRY PARAMETRIC STUDY
Posted 2011年3月9日 GMT-5 06:50 0 Replies
Please login with a confirmed email address before reporting spam
I have to do a parametric mechanical study with COMSOL 4.1 in 2D! The parametres involved are geometrical, therefore when they change the geometry changes. Specifically I have a concact (that I have to define) between two surfaces.
After having set the parametric sweep I run the model. Without definding any concact beetwween the surfaces no problem ... the geometry changes when the parametres change and I get a result (that of course is wrong since I haven't implemented the concact yet).
When I run the same program with the concact implemented I don't reach the end since, every time that the geometry changes, the lines involved in the concact (that lines enumerated by COMSOL) change as well.
Are there any way to do this parametric study without defining all the times the concacts?
Thank You
Giulio
Hello Giulio Ferrazzi
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.