Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error message

Please login with a confirmed email address before reporting spam

Hi.

When I have created my model, when I have computed it an error message has appeared.

The text was : "Failed to find consistent initial values.
Last time step is not converged."

Someone can help me to find a solution to this problem?

Thanks.

2 Replies Last Post 2012年9月24日 GMT-4 19:25
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年7月3日 GMT-4 08:54
Hi

Sorry cannot help much, but that means that your initial conditions are too far away from the final results, think over your model, give a best engineering guess of the dependent variables for the solved case (mostly better tha all "0" and try that as initial conditions, often it helps

And check: is the mesh compliant with the expected model results ?

--
Good luck
Ivar
Hi Sorry cannot help much, but that means that your initial conditions are too far away from the final results, think over your model, give a best engineering guess of the dependent variables for the solved case (mostly better tha all "0" and try that as initial conditions, often it helps And check: is the mesh compliant with the expected model results ? -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年9月24日 GMT-4 19:25
I had that same error and was able to fix it by changing the time step.

Go to Study> Solver Configurations> Solver 1> Time-Dependent Solver 1> Time Stepping (in the Time-Dependent Solver window) and change the Initial Step value (make it smaller by at least 1 order of magnitude.)
And this should solve it!

Good Luck

Kelley
I had that same error and was able to fix it by changing the time step. Go to Study> Solver Configurations> Solver 1> Time-Dependent Solver 1> Time Stepping (in the Time-Dependent Solver window) and change the Initial Step value (make it smaller by at least 1 order of magnitude.) And this should solve it! Good Luck Kelley

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.