Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Showing boundary not use for meshing and solving in result graphics

Please login with a confirmed email address before reporting spam

I created a simple beam bending model as attached to experiment ways to meet the goal. There is a rectangle beneath the free end of the beam. I used "Virtual operations->Igonore Faces" with "ignore adjacent edges and vertices" unchecked to hide it from meshing.

The edges of the rectangle are shown in the result plots. Is it a correct approach? Is there any simpler method? How about for an 3D/solid oject?

It seems that the solver has to run again to see a newly added rectangle.

Thank you.



0 Replies Last Post 2020年3月25日 GMT-4 00:34
COMSOL Moderator

Hello Panson Poon

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.