Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cross section simulation -results visualization

Posted 2013年10月9日 GMT-4 11:37 Results & Visualization Version 4.3b 1 Reply

Zelenyak Andreea Manuela Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,
does any one know how can I plot the results from a Cross section simulation into 3D Plot Group. So what I want is to see the 2D results into 3D geometry frame. It is possible?
Thank you very much
1 Reply Last Post 2013年10月23日 GMT-4 05:34
Bettina Schieche COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年10月23日 GMT-4 05:34
Hi,
one idea could be to define a 2D revolution data set and then add a slice plot in the 3D-Plot group. You can also try to use extrusion coupling operators.
Best regards
Bettina Schieche
Hi, one idea could be to define a 2D revolution data set and then add a slice plot in the 3D-Plot group. You can also try to use extrusion coupling operators. Best regards Bettina Schieche

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content