Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

comand ht.ntflux in the heat transfer module

Posted 2015年6月23日 GMT-4 04:50 Heat Transfer & Phase Change Version 5.0 0 Replies

Eugenio Benedetti
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,

i haven't undestand how to use the command "ht.ntflux" in the heat transfer module. that is, if i have a 3D line data set that it's not parallel to the principal axes how i can calculate the normal heat flux trought this line?

thank,

Eugenio
0 Replies Last Post 2015年6月23日 GMT-4 04:50
COMSOL Moderator

Hello Eugenio Benedetti

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content